Download the Mobile App
This app makes binding and managing drone connections simple in the classroom, allowing for great a high degree of control and customizability. Download the Orqa FPV.Ctrl App for IOS or Android
Binding to your Receiver
Open the Orqa FPV.Ctrl App
Turn on the Orqa FPV.Ctrl Radio
Select the device underneath Available Controllers and select Connect
Select Ghost Menu
Press the text that reads Bind, then on the secondary menu press Bind + Setup…
Change the radio protocol to SBUS
Connect a battery to the drone, the first time you do this the receiver will automatically enter bind mode. There is no need to press the button as in old receivers.
On the App, press Start Bind
Calibrate your Radio Gimbals:
Open the Orqa FPV.Ctrl App
Turn on the Orqa FPV.Ctrl Radio
Select the device underneath Available Controllers and select Connect
Select About & Settings, choose Calibration
Go through the steps as indicated to position the gimbals according to the animation. You will have only few seconds per position.
Connect to Betaflight and verify on the Receiver tab that the drone is responding appropriately.
The minimum values should be 1000, middle value 1500, maximum 2000
Ensure the simulated drone is not rotating with the radio gimbals at rest.
Reduce Radio Transmitter Power:
Open the Orqa FPV.Ctrl App
Turn on the Orqa FPV.Ctrl Radio
Select the device underneath Available Controllers and select Connect
Select Ghost Menu, then Tx Power
Set Mode to Manual
Set Power to 16uW (16 microwatts)
Adjusting Betaflight
Modes Tab - Adjust AUX and Range Settings for:
Arm - Left Locking Press Button (Aux 1)
Flip Over After Crash - Right Press Button (Aux 3)
Beeper - Right Press Button (Aux 3)
Leaving Angle Mode on Aux 8 with the entire Range selected